Originally Posted by shaggy2112

As you can see the plastic is just not wide enough to support the stress the bolts that hold the housing together endure. I measure about 2mm or so at the outside edges of the bolts. The top however I was unable to get an accurate reading due to the thinness of the plastic....Im guessing .1-.2 mm of plastic above where the screw that holds the diff case together. It is .1-.2 mm of plastic! This is a design flaw without a doubt. Tekno needs to add an additional 2 mm of plastic on top of the screw that holds the diff cases together. If your diff has not broke yet.... I can guarantee that it will if yours is like this.