Originally Posted by
cygnusx1
Moderate success with upload communication using your method. However, eventually, the software would simply crash when selecting the "Throttle" tab. I will try again if and when they release some sort of update. I will program using the Trackstar hand-held programming card for now.
Also, I run twin 6000mah 2s batteries as 4s. I set the Voltage Cutoff to Auto and it counts the four cells during power up fine. They say that Auto should cut power at 3.2V/cell. I had to put back 6300mah into my 6000mah batteries when I recharged them! You might want to manually select a higher cutoff voltage to save your lipos. I am going to change from AUTO(3.2v/cell) to a fixed 13.5V cutoff for my 4S setup.
RE crashing: I found this at first as well, but if you click on the DEFAULTS tab in GENERAL SETTINGS(after opening the program) ,the program no longer crashes when going to the throttle tab (on my setup at least). hope hobbyking update soon, maybe we should all raise a support ticket with them at the same time. I will contact them soon and see what I can find out.