Originally Posted by
Randy_Pike
Nick if the phone/app can read the software version from the esc, it's working. So when that screenshot was taken, what didn't work?
The guys are right, if you want to assure you get a clean full data log run, clear the memory each time you're ready to hit the track. Depending on what "streams" your recording you can record a few runs(time affects the amount of runs also).
However if I"m hard core testing and I need all the data, I clear the memory before I toss the car down by powering up the car, holding down the "inc" button until you hear a chime reboot.
Awesome - Fan in, LVC - 2S and Datalog i will clear
APP - it connects, but I only see the outline of the HW App - and the tabs on top - but no data is seen so I can't change anything. It also shows the Version of software in the ESC in the upper left corner so is connecting.
(SEE PIC on the LEFT)
If I am in DEMO mode I see some data that was there before I ever hooked up the ESC (which is just DEMO data).
(SEE PIC on the RIGHT)
PS - i have tried powering down phone - reinstalling HW App, disconnecting from ESC several times. Tried with ESC plugged into battery and switch on and OFF - however the app will only start in DEMO mode when any battery connected