Originally Posted by
eded1
Hi Randy.
I've load the 223 software and set to C1 or C2 after fresh loaded i switch to C1
and after switch off the dual mode it stay in sensored mode only and it work,
but when I switched to dual it is not possible to switch of the dual mode and go to sensored only.
I stayed in C1.
If you can help i appriciate this very much.
Ed
Hey, I'm i bit confused.
C1 and C2 are both custom. You can adjust the settings and "save" each by hitting "apply settings." Then if you wish to swap between them, simply select the profile you want, and hit "apply settings" OR you can use the onboard button interface to swap between profile 6(C1) or 7(C2) via the led tree.
Does that help?