Originally Posted by
Stano71
I found this info in one of the USBlink manuals somewhere,
Connect the ESC, LCD program box and PC according to the picture(same as turnigy manual). Run the USB Link Software.
And then connect ESC to battery and
turn it on, the USB Link Software will
try to communicate with the ESC. After
the connection is established, user
can easily set the ESC or update its
firmware on the PC .
have'nt tried to connect mine yet , but will post findings when I do,
also remember reading somewhere that the order of connection(as above) is important
Hope this helps
I tried exactly this method.
When the esc is connected to a pc through the card, the card displays "connected to pc". The fan turns slowly.
Opened the software.
Connected the battery and the led turns on and is red. The fan speed picks up. The esc beeps the number of cells.
Push the power button and it does nothing.
Click the "read esc" button on the software and it acts as if it's going to open and then closes completely.
Also, if you push and hold the power button, the esc shuts off and the software tries to open and then completely closes.
Something is wrong with the software.