R/C Tech Forums - View Single Post - Tekno ET48 Thread
View Single Post
Old 01-11-2014 | 07:11 AM
  #1201  
Mullet1
Tech Addict
iTrader: (16)
 
Joined: May 2013
Posts: 673
Default

Originally Posted by symmetricon
I got to drive a couple laps with the et48 with the box setup. The truck drove very nicely
I think the spring may have been a little too soft for out track, but it wasn't bad at all. Between the truck I drove and mullets, I noticed they both had some minor setup differences in the hinge pin insets I.e. orientation. The one I drove had a lot of turn in and pushed a little on exit. I believe it could easily be tuned to get a linear stable steering feel...... I wouldn't say it drives revolutionary, but it should definitely be considered by anyone who is looking to buy an e truggy. If I were to buy a new truggy, this would be the one for sure.
throw that busted DEX408T to the side and get a Tekno.
Mullet1 is offline