Originally Posted by
larshans1
Hello,
Purchased just before Christmas from RC Mart Speed Passion Reventon Pro 1.1 Brushless ESC w / Competition Motor V3 6.5R.
Mounted it in my B44, 2, and everything seemed ok for a few rounds.
I think I programmed it to "Stock1", has certainly reverse and brake ...
Suddenly it stops and the motor just slowly forward even if I do not give any throttle.
I turn the ESC off and on, so does everything seem to be fine for a few minutes or seconds...
Have tried several batteries, another motor, turning off temp and low voltage protection without result.
I have also tried a fresh installation without result...
Think it's easier if you look at the video I posted at Youtube. The error occurs one minute into the video.
It seems like I'm not allowed to link to other sites
http colon //youtu.be/wRpCU9p9YJE
Same here - wired it all up and the motor spun slowly in normal rotation, apply brake and it stops. Calibrated the radio to the TX and no go, nothing works now. (MT4 radio)
Tried sensored, unsensored, different RX, same RX different esc, 3 motors, 2 lipos ........ updated LCD, tried reseting esc ......
Nothing. Dead anchor ........ not too impressed
