Originally Posted by
DirtyDog3375
I have been running my X2 using the following:
- charging both channels maxed out (10 and 15 amps)
- MM Tire warmers at warm up and also maintaining at 60'C
- MM tire sander start up and also running
- MM LED pit light
- USB charging mobile phone
- Twin cooling fans
Using this loadout, it has not missed a beat and runs perfectly.
The internal PSU is rated at 45amps.
HTH.
Originally Posted by
NolanP
I've been running this setup since I got the X1 charger. I run all four ports off the X2. I will be adding the mini. If anyone wants to test the chargers I have them ready to go for anyone to use. I've never gone over 45 amps total. But I've run 35 not using the X2 chargers just using it as a power supply. It was charging some USB heli batteries.
Thanks guys.
So it's the total being drawn that actually matters?
I was worried about going over 10A on the extra outputs (can't remember where I got 10A from) so I haven't pushed it.
This means I can use my tyre sander as well as charging.