Originally Posted by
Carranza76
I kept your RM set up and switched to MM. I added the TLR weight kit also.
One thin I noticed and not sure what to do here, on the hinge pin block in the manuel it says to add the 2 degree insert in the block. But the tranny does not sit flush on top. Not sure if I am explaining this correctly. I will try to get a screen shot from the manual. I am still getting binding in the tranny also which is causing overheating issues.
Gonna try to a tear down and rebuild this week some time.
Edit: Parts number TLR2044 is what I am talking about.
In MM the tranny is not suppose to sit flush, you have to change that insert when you go from RM to MM, the MM has bigger holes where the screw goes through it and screws into the tranny, the RM insert the screw screws into it to secure the toe block as the tranny does not sit ontop of the block in RM form.