R/C Tech Forums - View Single Post

01-04-2014, 10:01 AM

#5308

Bigz84

Tech Master

iTrader: (24)

Join Date: Dec 2010

Posts: 1,059

Trader Rating: 24 (100%+)

Quote:

Originally Posted by mac853

Could anybody explain me if is this DRIVE SHAFT COUPLING which could replace original 305231 of Xray?

Does it worth to buy, then will not create loose since is smaller?

http://www.reflexracing.net/RSD-XRAY...ff_p_1753.html

Then about this 1 too, could it worth to buy since fits on V2 chassis of RSD?

http://www.reflexracing.net/SPR027-U...T4_p_1794.html

Best regards

Hi, let me take a crack at this..
your fist picture is a steering rack post, so no it will not work for the drive shaft coupling.

yes, this top teck, w/ the motor mount support will be a great tuning option, as I will be picking one up myself the next time I order thru them. this option lets you take out all the layshaft screws to alter traction of the car.

general question for all out there. Has anyone gone from the V1 RSD chassis conversion to the V2 conversion for 17.5 blinky, and if so, what did you have to change about the chassis setup? I was just wondering if you have a good setup on the car already, will it work for the V2. Also, what did you do about mounting the antenna mount as there is no hole in the top deck for the antenna tube to go up thru. as of right now, I just wrapped the wire towards the servo and bent the wire up, so it won't get tangled. What have others done?

Reply