R/C Tech Forums - View Single Post - Nitro On-Road
Thread: Nitro On-Road
View Single Post
Old 12-30-2004 | 03:12 PM
  #2223  
it's Avatar
it
Tech Regular
 
Joined: Feb 2003
Posts: 389
From: Bolingbrook
Default Re: engine problem...

Originally posted by judd
guys ang hirap nang i start ung engine ko (gs15r) to the point na lumalaki na ung biceps ko ayaw pa din mag start... nu kaya problem nyan?? minsan ayaw pa bumalik ung pull start.. gagalawin ko pa ng konti ung flywheel para bumalik... hrrrr.. nu kaya problem?? if ever how much ba mag pa tune up ng engine??? salamat!
Happy Holidays!!!!

Just be patient!!!

1. Make sure glow plug is good.
2.Make sure Igniter is good.
3.Make sure there is fuel on the line or @ least right by the carb.
4. Check if your fuel is still good. One time I had a lot of problems from O donnell 20%. Some of us might have a different opinion, but I did had problems with bad fuel especially here because its most of the time cold.

Hints!! Do not pull as much as 2 feet, this is not a lawn mower. If everything was correct 2 to 3 pulls the motor should start.

GS motors from Kyosho is like OS. So just try this. HIgh needle 3 from close, Low end 2.5 from close. Also, make sure that the line or the carb does not have a leak!!!


Hopefully this works and have fun practicing.!!!!!


BTW! If you just here in Chicago Every tuning is free. There are lot of Engine GURU here.
it is offline