Originally Posted by
slakr
Is there a conversion "kit" to get up to the v.2?
Or do you just have to get the parts? (*and if so, what are the parts?)
I'm asking about going from the EB48 to the EB48.2, not the lightweight conversion.
Right from the horses mouth
Updated XT arms front and rear (TKR5030XT, TKR5036XT)
+1.5 degree rear outer toe plate for more adjustability (TKR5013B)
New differential ring and pinion gears for smoother and quieter operation (TKR5151, TKR5152)
Updated internal differential gears with low wear cross-pin design (TKR5149, TKR5150)
Updated shock cartridge internals to minimize shaft deflection (TKR6008)
Updated upper shock mount bushings to increase consistency (TKR6008)
Updated rear inner bulkhead with larger bearing to reduce wear and increase efficiency (TKR5016B, TKRBB05134)
Hard anodized aluminum pivot balls throughout – reduces weight (TKR5049A, TKR5052A, TKR5053A, TKR5058A, TKR5079A)
Hard anodized aluminum front spindle and suspension bushings – reduces weight (TKR5054A, TKR5055A)
Aluminum steering posts – reduces weight (TKR5102A)
Aluminum front center driveshaft – reduces rotating mass (TKR5077)
Lightened differential outdrives throughout – reduces rotating mass (TKR5112X, TKR5114X)
Updated servo saver spring for more precise steering feel (TKR5101X)
Updated steering servo horn for better durability
1.0, 0.5, and 0.0mm offset hinge pin inserts for more adjustability (TKR5021)
Updated setup sheet for improved handling
depending how clapped out or not your is. Most likely be cheaper to sell yours off and start over