View Single Post
Old 12-25-2013, 09:23 PM   #6939
Join Date: Dec 2012
Location: south fulton tn
Posts: 1,175
Trader Rating: 13 (100%+)
Send a message via Yahoo to kyoshoracer77

Originally Posted by kyoshoracer77 View Post

Triple check the castle piece just to be sure. Installed a couple of these kits without issue. If you still have interference just faintly file the slot or backdrag a hobby knife across the edges of the alum to break the edge. Otherwise it'll be fine in about 5mins of runtime so long as it's not jamb up tight.
I took off some of the blue anodized and I was able to tighten it up fine.
Are the jconcepts ball ends as tight to snap on like the one on the sway bar?? If so I want them!!!!!!!!
kyoshoracer77 is offline   Reply With Quote