Originally Posted by
trerc
I always put the radio in bind mode by holding the bind button and powering on the radio. Then I put the receiver in bind mode by holding the button on the receiver while turning on the esc, I hold the button until it starts to flash. This of course has to be done before the radio goes out of bind mode, (as I'm sure you are aware of). Good luck.
The 92524 is an FHS2 receiver. The other one you me is most likely but if not it won't work until you change the settings in the TX
I don't know what the M8 TX is or if its even adjustable you may be sol.
Anyways on the MT4 you can change from FHS2 to FHS 3 to FHS4 and you need to do that per the receiver type. Then when you select bind it will work. Otherwise it won't bind.
Again the M8 may be only FHS2 since its older so you may not be able to use it. Try going into the system menu in the M8 and see if go can change the FHS type.
Aaron