Hi guys just some info listed below about sensor errors.

Red-Yellow/orange -green illumination on the esc is sensor error which actually is red - green just because it switches so fast its seems there is a yellow/orange and depending if it sunlight or dark shaded areas that your looking at it from.

Well anyway because we use 100% pure sensored signal from time to time you will get the errors for the following reason.

1. Sensor cable is faulty or come loose from either the motor or esc plus even a wire might have come our of the plug.

2.You motors rotor is not shimmed close enough to the sensor board halls sensors.

3.Hall sensors are damaged on the motor sensor board.

95% of the time the issues occur from the points sbove and not thr esc or its software.

I hope this helps you guys to understand how the whole sensor errors work and what to look for when the error does occur.

Thats with all the 1/10th xerun series.

For the sct pro and the xerun 1/8th both those esc's their software is designed to run a dual mode system were sensored is used on initial starting torque and then switches to sensorless mode during the run to avoid the large electro magnetic fields that the larger 4 pole motors produce so once in neutral on the throttle or on the brake the system switches to its original state of sensored etc etc until the initial torque has built up them sensorless once again