Originally Posted by
OnRDPassion
So today I went to the Tamiya test track and did a little R&D. It was tough day needless to say as the grip wasn't up to where it normally is and it was cold. I did however by the end of the day end up getting the car close to what I wanted.
Front:
6 Degree C-hubs
1mm under the steering ball studs for the ackerman
450 wt oil
Ride Red springs
0mm shims under the inner camber link
1mm shims under the outer camber link
5mm Ride height
5mm Droop +1 Degree toe
C in front
B in the rear
.5 mm shim under the blocks
Rear
450 wt oil
Ride Red springs
5mm Ride height
5mm droop
0mm shims under the inner camber link
4mm shims under the outer camber links
2 degrees of camber
XC front separate
C in rear
.5mm shims under the blocks
I was running with a Mazda 6 light weight body. I tried using the LTC-R and did not like it at all.
No kidding it was cold, I broke out my Sorex 20's today!
I was there with today my TRF418 briefly as well, had mine built according to kit. I'm not a very good driver or mechanic so I don't have anything to contribute
but I have a quick question. The ride red are they #28103 tq only has one left in stock