R/C Tech Forums - View Single Post - JConcepts Thread
Thread: JConcepts Thread
View Single Post
Old 12-10-2013 | 06:41 PM
  #6867  
PW's Avatar
PW
Tech Elite
 
Joined: Sep 2001
Posts: 4,786
From: Groveland, FL
Default
Originally Posted by Blackpearl#1
Just got the hi flow 0222 and got it all painted up and drywall tape and shoe goo. Looks GREAT!!! Now the question, I can clearly see the 4 hole locations in front and 3 in back but I have a 22 SCT and it is not listed in the diagram that comes with the body and now that the tape and goo is in there, well its hard to figure exactly where to punch the holes. Any of the premarked holes work? Sorry for the novel from a newby, but dont wanna screw this up. Any input is greatly appreciated.
Kris
For the rear of the body; the holes are the ones closest to the roll-bar, there should be a notch in the roll-bar for the holes.

For the front; I will have to wait till I get to work tomorrow to confirm, but it is marked.

Just hold off and I will confirm tomorrow.
PW is offline  
Reply