Originally posted by Crashby
Take your motor out and use your Dremmel tool (or hand file) to grind away the back edge of the T bar until you can get the correct gear lash adjustment. If you are using the center screw where the T bar mounts to the lower motor pod plate, make sure you leave enough T bar material to allow the center screw/nut to make a secure mount. If you still do not have enough forward motor movement, then you will have to make the motor mount holes on the left side motor pod plate longer. This is a little more difficult and time consuming.
or, u can just grind the motor mount holes for further mesh adjustment without messing with th T-bar