seem to be having a problem getting a 32T- 64P pinion on my 19t motor. It appears that the motor could move forward on the motor mount, but won't since it hits the t-bar first (this is a L4 by the way). Anyone experience this problem? I'm using box stock set up and the included 100T spur. Strange thing is that the manual specs a 35T for a stock motor, and I dont see how that could fit either, did I do something wrong???
i ran into the same problem, to correct this i took the middle t-bar screw,nut and spacer out and grinded the t-plat just a enough so that i could ajust the motor better(better gear mesh)..i didnt notice the t-bar/car tweaking during the race or having to retweak inbetween rounds..
hope thats what you looking for?
Oh YA! i went down to a 96spur
lazy