Originally Posted by
Boss Ross
Inboards. I have a set of balance leads and running leads for each. The running bullets are tight and show nominal wear. I checked voltage this morning and the "gave it up too early" race loser was at 3.79 and 3.82. Been charging @6A for almost 3 hours now... reads 4.19/4.20 and loaded 4900mah. I don't get it.
The PL6 comment lead to an all nighter on chargers and PS. I think I could do those, and a couple of the HP 1200s. Trying to wrap my head around the MPA setup as I run both 2s (SMC) and 4s (TP), and usually have 4 ports going on any given race day.
I would send Danny an email and explain to him everything you have told us here. Go to the smc webpage and the contact us will go straight to him. Danny might have some idea of what happened or is happening. He does alot of research and testing on lipo's and may have some better insight.
Like I said my bullets felt like they were tight but my issue went away after I changed them.
If you email him tell him I sent you from here, he will get back to you and probably ask more questions.