Originally Posted by
Blown up
Anyone try to bolt a tekin Gen2 6.5 to this motor mount? The tekin I have doesn't line up w/the screw holes in the motor mount... The gen2 srcew holes are a smidge wider than the xb4 mount holes. I ended up bolting an LRP X12 7.5 in no problem. Tons of room in this rig compared to other wheelers I've had, wiring came out slick. I need to pop off the top deck to route a new sensor wire and I'll take a pic.
I run a Tekin gen2 5.5 and 7.5, along with a gen 1 10.5, which I've just been enjoying running indoors. All fit fine, but you need to put both screws through the mount, align them to the holes, get each started a few turns. then do them both up tight. screwing one in completely, then the other it does get out of alignment.