R/C Tech Forums - View Single Post - Frony bearing change on an Associated. .15 engine
Thread: Frony bearing change on an Associated. .15 engine
View Single Post
Old 11-18-2013, 07:38 AM
  #2  
Rcrenew
Tech Elite
iTrader: (9)
 
Rcrenew's Avatar
 
Join Date: Jun 2010
Posts: 3,077
Trader Rating: 9 (100%+)
Default
Originally Posted by mattjk
I need to change the bearing on my engine. it is sounding gritty and the stock bearing has a metal seal.

is it ok to install a rubber seal bearing made for an axle? i run on a very dusty track so i would like a rubbet seal to keep the dust out but im worried about the fuel eating the rubber. are there special engine bearings? i am only finding non engine bearings in this size.


thanks
You need to use an engine bearing, they are different than standard bearings and axle bearings. But you can use one with a metal shield or rubber seal.
Last edited by Rcrenew; 11-18-2013 at 07:40 AM. Reason: Spelling
Rcrenew is offline  
Reply