Originally Posted by
evochick
yeah black bladders for the win, the other thing to make sure is that when you tighten down the cap retainer you are not turning the shock cap as well,
Speaking of issues i installed Tamiya front ecs drive shafts, as i prefer the clip type to hold the pin in, and they were a pain to get right without the hex clamp binding down on the bearing when you tighten up the wheel nut. I had to modify slightly a set of 3racing clamps to get them to sit at the right spacing so they sit on the pin and not the bearing. A pain but worthwhile.
Beth.
Its best to just convert the hexs to Tamiya. Their hex design is a lot better.