Found this fine tooth, 1" hole saw at lowes made by DeWalt. Its awesome!



Cut the hole like a hot knife through butter and very clean cut too.





Installed the plug using some left over m3 screws, washers and lock nuts. I do have some silver stainless steel screws on the way however.





Last but not least, is the beefy power plug, this thing is official!



Im slowely receiving switches and encoders piece by piece. I did find someone local who will help me with the CNC needs. That's a huge weight off my shoulders too. Also thinking about praying the entire outside of the case with truck bed rhino lining that's sold in spray cans. Should be an interesting look. I will update more as it comes!