The Fuse ESC works fine in a wheeler, they are actually a lot smoother
than most people think. Make sure you set the Start Power, Throttle
Speed and timming back to there lowest settings. Also you will NEED a
fan. Either the Castle or Dynamite motor will work I just prefer the 3800.
It will also need to be geared up several teeth beyond the normal 6.5-8.5
gearing.
Here are my ESC settings
1.Brake Strength-3 (I would run this as low as possible to keep strain off the
diff gears)
2.Drag Brake-1= 0%
3.Throttle Speed-1= Very Soft
4.Start Power-1= Very Soft
5.Reverse Power-1= 0%
6.Run Mode-1= Forward Only
7.Motor Timing-2 =soft
8. Battery-4= light lipo discharge
Any suggestions on gearing with the standard spur? Not sure what 4 pole 3300kv equates to in turns.