Here is What I run
Front:
Shocks 35wt #2 pistons Blue Springs
-0.5mm on the A-arm blocks (or just don't use shims)
0 degrees toe about -.75 degrees camber with the 4 degree caster blocks
5.5mm Ride height with 2mm over ride height for droop
Second from the most inside upper camber link hole with 2mm shim under ballstud
Rear
27.5wt Green Springs #2 pistons
-.5mm on the a-arm blocks or just run no shims
3 degree tow block
2 degrees camber
5mm ride height with 1 to 1.5mm droop (over ride height)
most inside camber link hole with 3mm shim under ball stud
Lots of ppl at the track think this setup will not work but it works for me. I brake into corners and stay tight
If you overdrive this setup it will byte you in the can. just sayin.