Not a weird question. I started with the 3 wires already soldered to the ESC. Then I figured out how long each piece of loom needed to be and cut it. Next I stripped the 3 wires and tinned them. After the wires were cool enough, I slid the loom on and cut my shrink tube to the length I wanted. Slid the heat shrink tubing on over the loom and lined up the end of the shrink tubing to the end of the wire insulation and shrinked the tubing on. I let it set for a couple minutes and then soldered my wires to the motor. Really easy to do and makes the wiring look a little better.
Hope that helps ya!
[IMG]
[/IMG]