Originally Posted by
kuruption
So based on that chart, using the "stock" settings you have highlighted... are you running 1.5mm narrower in the rear compared to the standard T4 settings or is that 1.5mm narrower compared to using 1-out front and rear? If the latter, how does that track width of -1.5mm compare against the stock T4 track width?
It's the former, -1.5mm is representing narrower than maximum possible width, that's very close to the same as the stock XRAY t4 pins.
Like you, 2 dot outside RF and RR results in about 3.5* of toe... and I thought about doing 2 RF / 3 RR to get down to 3* but seeing your chart makes me wonder if I should go w/ that 1.5mm narrower setup and put on the +0.75mm hubs?
I'm currently running 3rf inside and 2 rr inside. This gave me 3 degrees, and the same track width as the stock car.