Originally Posted by
HeavyD99
I am hoping that the 2014 spec includes machined 1.6 and 1.7 2-hole pistons...i tried drilling my own but messed them up - the holes were a little oval and not as clearly thru the piston as I'd have liked.
Did you use a power tool? If so do it by hand next time and you'll get an accurate hole
Originally Posted by
mccoy
thx Joey..so turning out a 1,5 piston into a 1,7 is not a bad idea at all..but what king of drilling mesh did u use.. 1,7 is on the small side..is it a specific kit?..thx
you could order online:
http://www.amainhobbies.com/product_...ston-Drill-Set
or just froogle: 1.7mm drill bit and buy the 1 bit for around $3.00 (metric bits are not popular in my area so I had to order online)
and yes you are correct. Front 1.6 with 40wt losi and Rear 1.7 with 32.5wt losi
(of course different tracks and temperatures play a part of it but its a starting point for you)