R/C Tech Forums - View Single Post - Serpent Cobra 2
Thread: Serpent Cobra 2
View Single Post
Old 10-16-2013, 09:48 AM
  #1  
codeman
Tech Regular
 
Join Date: Aug 2013
Posts: 257
Default Serpent Cobra 2

Hi guys,

Looking to sell a Serpent Cobra 2 kit in excellent condition, with a couple upgrades and a whole seasons worth of spares.

I intended to race this kit, but remained as my backup/"practice" kit (ie. run a couple times then sat on the table) - went with a Kyosho MP9 instead, but hard to sit on a pile of $$ invested in a kit I'm not using now.

Kit comes as rolling chassis with upgrades and spares, no electronics or engine. Nicely painted and meticulously trimmed body included.

Installed Upgrades
- front and rear aluminum chassis braces
- 8 hole 1.3mm conical shock pistons (front and rear)
- webbed bladders (front and rear)
- hard servo saver spring
- motor saver air filter outer-protector (x2)
- aluminum wing stays

Spares (too many to list almost!)
- front and rear inner/outer C-hub bearings
- full spares of all pivot ball ends
- front and rear set of extra drive axels
- spare front C hubs plus bushings
- spare front arms
- spare front and rear shock mount sets (all plastic parts that wear)
- spare set of driveline pins
- spare screws and washers for front and rear tower camber link mounts
- 2x carbon, 2x aluminum clutch shoes
- spare brake tower and cover set!
- 4 spare shock caps


Asking $650 or best reasonable offer. Shipping at buyers expense.





Last edited by codeman; 10-17-2013 at 07:10 AM. Reason: forgot some spares & upgrade :)
codeman is offline