Originally Posted by
pimpedaccord
I noticed that a while back that either the manual or exploded diagram had the wrong p/n. Can't remember which. The exploded diagram also has some nitro stuff left on it.
Originally Posted by
hacker07
Yeah, that is my bad. The part number on the step in the instructions is wrong...it is however correct in the exploded view.
Thanks for posting this. You guys just saved me a lot of head scratching. My 8e 3.0 kit had a bent dog bone for the front center. I called customer support and they had a replacement out to me in a matter of 2 days, so two thumbs up for customer support!! But the bone they sent me was the 242001 as it was listed in the manual. Its about a half inch shorter than the one that came in the kit. I was going to ask this question on here, but you guys already answered my question!! Just called customer support again and they are getting the right 242002 bone sent out for me now.
Ryan, make sure you get whatever the customer service guys use for reference updated with the correct part number. Even they are confused. LOL.