Originally Posted by
RCFREAK
Here is a tip to cut the time of swapping out swaybars. Also a way to keep all the mounts from falling on the table or ground resulting in lost time and lost pieces.
Step 1. remove stock screws,(discard over the shoulder) insert longer screws! You will never have to fiddle with the mounts again.. long screws will all you to loosen quite a bit,turn the top mount 90 degrees and remove and insert new sway bars instantly!
Process now takes less than 10 seconds!
Simple but very effective= OPTIMIZED!
Super tip, kudos for sharing!
Better than grease too imo.
I will see how I get on with both ideas but the longer screws is definitely sounding like the better long term optimized option!