Thread: Xray XB4 thread
View Single Post
Old 10-07-2013, 03:31 PM
Tech Elite
iTrader: (42)
aloksatoor's Avatar
Join Date: Dec 2010
Location: N California
Posts: 3,099
Trader Rating: 42 (100%+)

Originally Posted by BentKa View Post
That's the beauty of Xray and their manufacturing tolerances compared to anything US made

You mean US owned china made :P. All the homegrown US based shops who do their machining inhouse are as close or better than xrays machining. Definately the aluminum used by xray is not as good (I broke two rear uprights on the xray 808e aluminum machined but never any plastics thats a 50$ part each!!).

Aftermarket machined cf/aluminum parts are some of the best here BCE chassis, team SR towers. If I followed xray recommendations for their xb4 front towers I would be 200$ poorer by now and left with shards of CF haha the 4mm team sr tower works like a charm!!
aloksatoor is offline  
Reply With Quote