Old 10-05-2013, 12:45 PM
  #168  
howardcano
Tech Elite
iTrader: (37)
 
howardcano's Avatar
 
Join Date: Jan 2012
Location: Olathe, KS
Posts: 3,745
Trader Rating: 37 (100%+)
Default

Originally Posted by rctrackman View Post
I'm sure you're right. I was relating to a particular problem I had trying to mount a HPI 200mm Supra body on my CRC. The body has no "hip" below the roof line so the wide body mounts simply had no where to go. Thank goodness I could mount the posts a little inwards on the CRC thus providing me the ability to drill holes in the outermost roof area.
That's the same problem I had with mounting the Protoform Sophia on my SpeedMerchant chassis. The posts go through the side windows! Looks like heck.

One possible problem with the SP body is that the rear wheel arches look a bit narrow, so the rear tires can rub on their inside edge. The Protoform Mulsanne has the same problem. Fortunately, one minute with a hacksaw blade and a tire truer is all that's needed to remove the offending area from the tire/wheel. The narrower tire doesn't seem to hurt the handling at all.

Last edited by howardcano; 10-06-2013 at 05:32 AM.
howardcano is offline  
Reply With Quote