R/C Tech Forums - View Single Post - Serpent S411
Thread: Serpent S411
View Single Post
Old 10-02-2013, 12:21 AM
  #5915  
nathan c.
Tech Rookie
 
nathan c.'s Avatar
 
Join Date: May 2013
Posts: 8
Default

I use a 1mm shim between the servosaver and servo, and with a little bit of trimming on the sides of the servo saver it allows the servo to move freely.
Are you using the right servo saver insert that matches the number of teeth on the servo ?

Last edited by nathan c.; 10-03-2013 at 09:41 AM.
nathan c. is offline