R/C Tech Forums - View Single Post - Trinity kill shot motors
Thread
:
Trinity kill shot motors
View Single Post
09-30-2013, 01:32 PM
#
255
JamesL_71
Tech Master
iTrader: (
13
)
Join Date: Jul 2011
Location: Austin, TX
Posts: 1,117
Trader Rating
: 13 (100%
+
)
I would put money on the 0deg endbell timing being the cause of the failures... Zero on the Killshot is actually a true zero degree alignment, which is 30deg below most other motor's nominal zero position.
Reply
JamesL_71
View Public Profile
Find More Posts by JamesL_71
View iTrader Profile