Hope this gets read
T3 2011 rebuild questions
Hey people, trying to get my car ready for the fall.
Question about the hinge pins and shimming.
Following the build instructions it says a 1mm shim in front and behind on the front suspension - this leaves a heck of a lot of slop for the front arms to move.. I always remember this being a bad thing.. is there something I am missing here? The back shows 5mm worth of adjustment for wheelbase.
I also note that Xray talks about 5mm worth of wheelbase adjust with the rear, but does not talk about adjustment in the front.. is this on purpose.. is there a reason you would not want to shorten from the front?
I bought this car used, so there are things I am finding out during the re-build, and I noticed the pin supports are using the lowest setting lowering the roll center, is this good for Niagara? or should I go back to neutral, I dont think high roll centers at Niagara is the right setting?
thanks
James