Originally Posted by
dj apolaro
He is my set from the Nationals.
The form did not let me fill the rear data for some things
-Rear droop = 3.5
-Rear roll center = #4 (1 down from the top)
-Rear Ride height = 6.75
-Rear camber link = short and with no shims
-Rear upper pin = middle and inner position
-I used the rear shock extensions also. Used lower position hole
-In the final I ran 3.4 rear springs to help prevent traction roll
If I left anything out just ask.
Thanks,
DJ Apolaro
Hey DJ, well done and thanks for posting the setup sheet
Could you kindly confirm that you ran the front diff 100,000 and in the rear you used 200,000. Where you using the Kevlar diffs?
Re the Lower rear roll center stock setting is -0,5 could you kindly advise if its lower than that as I did not understand
Thanks