Sorry I have been out for awhile guys, lots going on with the Worlds being this week!!!! For those of you that know me personally I do much more in the industry then just Enigma Chassis Slaps...so my time has been limited on this project for the time being.

As for Joey, thanks for uploading the pics and I will consider making the RC10 Chassis Slaps a bit longer to go up the rear end a bit more.

As for the purpose, much like other stated, it is suppose to do both, add style and actually protect your chassis from getting hammered on. People have said that on indoor clay(really high traction indoor clay) it helps make the car glide off jumps smoother, and land a bit smoother with less friction on hard impacts. Now this is something that I cannot PROVE, but if you think about it, it does make sense. However the reason for me starting this company was to protect the chassis. In many cases people can notice a huge difference on wear and tear on their vehicles! With most cars going to some sort of metal type chassis, I think chassis tape is going to be a very important accessory for people trying to resell their cars, and or just wanting to keep them nice looking. As for the Kyosho RB6, the first few batches of chassis were thin thus leading to some deformation in the back tranny case slot on the chassis itself, we applied chassis tape to 3 different RB6 cars with those chassis and it seems that it had a big part in keeping the thin metal from denting as much, along with keeping ALL scratches off the chassis and on the Chassis Slaps themselves. Another awesome factor is it keeps dirt out of the bottom of the screws for faster tear downs/rebuilds...AND you can use our product over and over again on some surfaces without it loosing its "sticky" stuff Hope this helps!

And thanks for all the support you guys!