Originally posted by FUK_WRX
Hey guys is this part worth getting, what are the advantage of using these parts? And is this for the older rear end or is it for the V2 arms?
It's for V1 rear, not V2.
I personally hope K-factory can do V2 rear hub in similar material and design with front hub.
btw
I already kill 4 (ya, you read it right) rear hub due to sideslip knock on wall. A advice for all people here: using a LONGER screw on upper link of rear hub. I was using 12mm one but with a small sideslip hit, entire screw will breakthrough the rear hub wall and kill the rear hub. Worst case: because the rear hub is damage, it will also kill the CVD if the car just happen to run at high speed (yes, total casualty count is 4 rear hub + 1 CVD). Now I'm using 15mm and it seems to be much secure and durable than 12mm screw.