R/C Tech Forums - View Single Post - Spec-R R1
Thread: Spec-R R1
View Single Post
Old 09-21-2013, 08:20 AM
  #1977  
PROMODVETTE
Tech Elite
iTrader: (70)
 
Join Date: Dec 2004
Location: Marietta, Ga
Posts: 2,546
Trader Rating: 70 (100%+)
Default

Just got the pro version partially assembled and ran into this issue.

The motor/shaft mount pieces and the bulkhead are different heights....why??? But here is the issue, it says to put 1mm spacer on top of the motor/shaft mount to equalize the height. That doesn't do it. Still tweaks the chassis bad when you do this. Anyone else run into this and have a solution?
PROMODVETTE is offline