R/C Tech Forums - View Single Post - Brushless Hobbies & Stan
View Single Post
Old 09-11-2013 | 07:49 PM
  #22  
tc5 man's Avatar
tc5 man
Tech Prophet
 
Joined: Oct 2007
Posts: 16,997
From: levittown pa
Default

Originally Posted by shocker1
I too had lt4. I too no longer have lt4. I too agree on poor customer service,didnt even aknowledge email. Lt4 did not fail due to abuse, wrong gearing,bad battery,as the truck never had the tires on the ground. My opinion is to stay away from BHR and stan !



All i can say is i never had a major issues with the LT4 on my 4x4 SC i have two of them . To be honest even bigger named ESC have issues out of the box or not ive seen it it happens. The only thing i hate is the cap board its just something else to get in the way or pull a loose wire.

Ive ran the ESC for a long time and its been though diffrent surfaces etc and held up good. Granded i run my as non sensored setup but its pretty smooth so i dont know if i have a need for sensored.

I just ordered a extra Cap board from BH and i got it pretty fast in the mail did not get ripped off even with the extra ESC. So i would tell others that i know to buy one.

Customer service well heres the hard truth that when you buy things cheaper your not going to get that good of a service.



I was reading the post on the first page and i noticed that two guys said they had issues running Tenshock motors on 2s with the LT4 ESC . Im not sure why it would have issues on them its always ran fine with my 401/ 4600 kv Tenshock on 2s.

Last edited by tc5 man; 09-11-2013 at 08:05 PM.
tc5 man is offline