R/C Tech Forums - View Single Post - High Voltage servos on Lipo
Thread: High Voltage servos on Lipo
View Single Post
Old 09-10-2013 | 05:51 PM
  #2  
Lason
Tech Apprentice
iTrader: (1)
 
Joined: Feb 2003
Posts: 88
From: DFW, Tx
Default
On the plug going from the ESC to the reciever, either clip or remove the pin for the red wire. Then solder a small gauge wire to the positive battery wire at the ESC and run it straight to pin you removed at the reciever.

Basically bypass the BEC in the ESC.
Lason is offline  
Reply