Originally Posted by
HeavyD99
On my wish list - 1.6mm & 1.7mm 2-hole pistons!
(side note - I tried to drill out some of my own pistons, but again, there's the stock part blow by and the holes came out a little bit oval-shaped due to my unsteady hand).
May have to order up some Avid 2+2's!
my buddy has some avids and they are a bit too tight. My other buddy is using kyosho big bores. Im almost tempted to get the RB Products "A.D.S."
I drilled mine out to 1.6F and 1.7R
Originally Posted by
Odin544
Link?
http://www.hudy.net/xhudy/news/newsd...&kategoria=194