R/C Tech Forums - View Single Post - Kyosho V-ONE RRR EVO 2
Thread: Kyosho V-ONE RRR EVO 2
View Single Post
Old 09-09-2013, 02:01 PM
  #2795  
el salvador
Tech Master
iTrader: (7)
 
el salvador's Avatar
 
Join Date: May 2006
Location: Western Seattle Bucko!
Posts: 1,077
Trader Rating: 7 (100%+)
Default
Originally Posted by maRRRco
No issue for me about offset, I can correct it with a new setup, but I'm worried about the possibility to fit Nt1 hexs, kyosho uses a 6mm hole.
Did you know if xray has also 6mm hole ?
For example mugen hexs don't fit !
Sorry for not being more specific, Yes the Xray hexes will fit the RRR's 6mm axle shafts. There could be a limit on the cross pin length the Xray hexes will accept though.
el salvador is offline  
Reply