Ryan or Casper,
I'm starting my build today and have a few questions.

When building the servo saver, do we really back the nut off 5 1/2 turns or should I lock it down? The SCTE 2.0 we locked it down tight.

Also I'm assuming that the front clip has 10 deg. build it and 15 deg spindles like the SCTE 2.0. Is this right? On setup sheets that say 27 degs, that would be plus 2 on the hinge pin inserts (1 up and 1 down). Am I right in thinking this?

Thanks Guys!