Originally Posted by
Sunkist
Installed a whole bunch of alloy and graphite options over the past few days. Also received my speed passion reventon pro and yeah racing hackmoto 13.5t and installed and configured last night!
This chassis is soooooo much better with the right things!
The steering column is a tad wobbly though. Any pointers? I remember reading about changing the bearings for larger ones, but can't find that infor anymore
Use the Tamiya posts...tighter tolerances. Caseymacgyver used long setscrew then thick washer on top then nylock nut to tighten it down.
Originally Posted by
gerritcoetzee
I have installed the alloy C Hubs from 3 Racing, when I screw in the grub screw that holds the hinge pin in the lower control arm, it does not hold the pin in place, anyone had this problem or know how to fix it?
I would grind down a small flat spot in the middle of the pin...just like how you should have done on the CVDs (something for the set screw to bite into then thread lock the set screw sp that it does not back out.