R/C Tech Forums - View Single Post - TLR TEN-SCTE 2.0 Kit Thread
View Single Post
Old 08-27-2013, 09:46 AM
  #5080  
Purdue Engineer
Tech Regular
iTrader: (8)
 
Purdue Engineer's Avatar
 
Join Date: Oct 2008
Posts: 407
Trader Rating: 8 (100%+)
Default

Originally Posted by Grandturk
A - loose is fast. In general these trucks get better with some slop. I wouldn't worry about it.

B - check the pivot balls in the ball ends. I've run my truck hard since it came out in March and its only about ready for new pivot balls. I will only replace these when the ball is so worn it will not stay in the plastic rod end.
It's funny you bring that up. I was just changing the rodends on my truck just now. I used the old balls and just replaced the plastic (#LOSB4023 I think) and there is twice as much slop in it now than there was with the old ones.
Casper or Ryan, what part number do I need? These will not work. The ones that came with the truck were a lot better when first assembled. The balls are not bad because some are still ok in the old plastic rodends.
Thanks
Purdue Engineer is offline