R/C Tech Forums - View Single Post - Tekno SCT410 Thread
Thread: Tekno SCT410 Thread
View Single Post
Old 08-24-2013 | 06:23 PM
  #13950  
ChuckTee's Avatar
ChuckTee
Tech Addict
 
Joined: Jul 2013
Posts: 741
From: San Jose, California
Default
Originally Posted by moto44
Just took my SCT 410 out for the first time. The only problem I was having was the motor was running hot. I have a Tekin RX 8 and a Tekin 4600 motor with a 15T pinion. Forgot my temp gun but after 5 min of run time I could feel it was running to hot. A buddy of mine is running the same set up with no issues. Any suggestions?
I ran into that last time at the track and turned out to be a bad sensor wire, replaced it and all better. Go figure. Good luck
ChuckTee is offline  
Reply