Originally Posted by
acuglass
@wollow86 - well hope yours is just a case of replacing the sensor cable - SP provides a very short cable and in order to fit, we sometimes overstretch it and end up with a loose contact; or checking gear mesh (...this one produces a very loud and rough sound) or well, while your at it, check tightness of pinion grub screws - I did experience this loud and rough sound with one of my pinions (29T48P) before, i think the pitch doesn't match my spur's...replaced it with a better one.
V19 is available in my choices for update firmware at SP Interface. I do have Muchmore Fleta installed as well.
The problem is there without the motor installed in a car. I've tried just about every combination of motors, sensor wires and software I can. All the motors and sensor wires work fine with a different esc. Only possible thing left is a hardware fault with the esc sensor board.